Lies of p switch software#

I've attached sanitised configurations from one of the routers and its associated switch module. I want to use the EHWIC to connect the two switche modules (freeing up the 1 gig on-board port), and to connect the Linksys switches into the fabric via a trunkДoes anyone know if there is ANY way to have the new 4 ports in the same fabric as the existing 24 (26, counting the virtual ones) ports from the SM module? The EHWIC also doesn't appear to support etherchannels, which is a bit disappointing. However, I can NOT see any way short of physically connecting the SM module and the EHWIC to integrate the switch ports in the EHWIC into the existing fabric/VLAN configuration.

Lies of p switch software#

I have purchased an additional EHWIC module for each 2911 - an EHWIC-4ESG - and installed it, upgrqded the software to the point the router recognises the new ports and got a basic configuration for them. Unfortunately, there are also a cascaded Linksys switch hanging off one of the 100 meg ports on each switch module. The SM-ES3-24-P module conencts to the router via an internal backplane link which presents as a pair of psuedo-1gig connections (only one of which is actually used in this configuration, for some reason), with some trunking configured on the router ports and a single, 1 gig link between the switch modules to give connectivity. Unfortunately, they had their network built by a 'systems integrator' who didn't give much thought to the future.Д«asically, the core of the office network is two 2911/K9 routers with an SM-ES3-24-P module in them, giving 3 routed ports and 24 switch ports. I've recently statrted a new position with a much smaller company which is just coming out of a startup phase. This is going to be somewhat long and involved for what I suspect will be a quick answer, but I need to layout the situation.